Pleasant day to all the Haynes techs. I am requesting your knowledge here. I have manual 92007 and am working on my 97 camry 4 cylinder. I have replaced my passenger side and front engine mounts, they were both cracked. I need to replace the last 2: driver side trans mount and rear mount. the bolts holding the driver side trans mount to the transaxle are impossibly close to the engine cradle. its a very tight reach to access them. do I need to raise up the transaxle a substantial amount in order to get at those bolts? or or do u recommend I loosen the engine cradle bolts and lower the cradle to get clearance to remove the mount fasteners? and as for the rear mount, any ideas on how to remove that top mounting nut? seem like I need to loosen one or more mounts to raise up the engine enough to get the old rear mount out. your input is kindly appreciated. thanks.