PDA

View Full Version : Install boss performance module



LUDA2106
04-01-2010, 12:34 AM
Its telling me to find the (iat) sensor. In the book on 6-10 it tells me but does not show me a picture of it. I was wondering if the (iat) sensor is the same as the (maf). And if i can just wire the black and red wire on the module to the black and red wire of the (maf)? I tried to find the schematics for the (maf). Please help me.

admin
04-01-2010, 04:34 PM
Hi LUDA2106,

We don't get involved with the installation of aftermarket performance products like you're describing. However, if we knew what kind of car you are working on and what manual you are using, we could help you as far as your IAT sensor goes.

On some vehicles the MAF and IAT are combined into a single unit, but not knowing what kind of vehicle you have, We can't tell you if yours is like that or not.

Email one of our tech service reps at research@haynes.com. Give them the number/letter combination on the first page of your manual, just to the right of the Haynes logo - it looks something like this: (4R2 - 96709). They'll do what they can to help.