PDA

View Full Version : install timing belts on 89 subaru gl wagon 4x4 w/ fuel injection



stichn56
01-17-2010, 09:29 PM
i went to the library to find a manual for this vehicle. what i need is a display showing the procedure. i already know whats #1 cyl. loc. also i already know that when setting up pass side belt, the timing maarks pointing up. at the same time, the tim mark on drivers side or left side is down at 6:00. the dist was point at # 1 on the cap loc. I went to start, and backfired once. I have fuel, spark, tim , all dead on. I then pulled the dist out rotated 180, then installed, the car ran. Can anyone email me or refer me to a source where i can print the display showing the front assembly to make sure i have all thing in place correctly. I am beginning to think the belta are off.

admin
01-18-2010, 04:31 PM
Hi stichn56,

You'll find that procedure in Haynes manual no. 89003, Chapter 2B, Section 5.