PDA

View Full Version : Buick Skylark Crankshaft Position Sensor



rellsun
06-16-2009, 03:31 PM
So i have a 1993 Buick Skylark v6 3.3l and i am not getting any spark. so i changed out the ignition control module and the coil packs and am still getting no spark. Which leads me to believe its the CKP sensor so how do i go about replacing the sensor. thanks

admin
06-16-2009, 05:23 PM
The repalcement information is on page 5-11 of your Haynes manual #38025.

rellsun
06-17-2009, 01:56 AM
thanks i was having trouble finding it and on the crankshaft balancer removal part it says just stick screwdriver in the fly wheel? i dont need a special tool? its on page 2e-7

admin
06-17-2009, 04:15 PM
rellsun -

Usually no special tool is required. A big screwdriver wedged into the ring gear teeth has always worked for us.

rellsun
06-18-2009, 02:15 AM
thanks and boy was that crankbolt on tight i had to use a jack to lift the wrench to break the bolt free.

admin
06-18-2009, 09:04 PM
Whoa! Yes, they are usually really tight. Good usage of the jack there!