PDA

View Full Version : 1995 Villager Mercury Ignition Acuator Pin



folsomnewdad
03-20-2009, 01:28 AM
I have the Haynes Mercury Villager & Nissan Quest 1993 thue 2001 manual. My ignition acuator pin is broken. I can start my van, but not shut it off. I can no find in the manual how to replace this piece. Can you help?

admin
03-20-2009, 02:53 PM
Hi folsomnewdad,

Are you referring to the pin that protrudes from the ignition switch? If so, that's part of the switch itself, which is covered in Chapter 12, Section 8 of your manual (there's a good view of it in illustration 8.13).

If that's not the part that's broken, email one of our tech service reps at research@haynes.com and explain the problem. Also give them the letter/number combination on the title page, just to the right of the Haynes logo. They'll do what they can to help.

folsomnewdad
03-20-2009, 03:34 PM
That is not the part that is broken. Ch 12 Section 8, Replacement (ignition switch), 1995 models and earlier: refers to "disengage the ignition switch from the actuator pin and remove the switch". It's the actuator pin that I'm referring to. I've attached a picture of the pin.

I will email tech support.

Thanks in advance for your help.