PDA

View Full Version : 2005 Silverado driver side mirror replacement



NMmtnbkr
10-26-2007, 05:29 PM
I am trying to replace a drivers side mirror for my 2005 Silverado and according to the Chilton repair manual (28625) you are supposed to unplug the electrical connector. The mirror wiring harness disappears down into the door and there are no instructions on what to do from that point on. Was that part left out of the manual? I have made an attempt to remove the door panel but without proper tools am afraid that I will do more damage then good. Is there a simple way of removing the panel? Thanks, NMmtnbkr

Mike F
10-26-2007, 05:39 PM
Hi NMmtnbkr,

Sometimes it is necessary to remove the door trim panel to access the connector. Door trim panel removal is covered in Chapter 11 (page 11-13, Section 15). If you have any further difficulties, contact us at research@haynes.com.

Thank you for using Haynes manuals!